Command an Ublox senden
|
26.12.2014, 09:55
Beitrag #1
|
|||
|
|||
![]()
Hallo zusammen,
vielleicht weiss ja jemand aus eigener Erfahrung, wie man Konfigurations-Kommandos an ein Ublox GPS Modul sendet? Mir sind die rund 65mA Stromverbrauch des Moduls zu hoch. Nun gibt es neben dem Performance Modus noch zwei weitere Modi, welche über UBX-CFG-RXM softwareseitig konfiguriert werden können. Hat das jemand hier schonmal gemacht und kann mir nen Tipp geben? Hier ein Auszug aus der Power Management Application Note: "u-blox 6 offers the option to change the operating modes via software. The following operating modes can be chosen by using the message UBX-CFG-RXM: Maximum Performance Mode enables the full capability of u-blox 6 positioning. This should be used if GPS performance is the most important consideration. Eco Mode provides slightly reduced current consumption with nearly the same GPS performance as Max Performance Mode. Power Save Mode allows significant reduction in system power consumption with reasonable GPS performance. Cyclic tracking operation is recommended with moderate to good signal conditions where position fixes are often needed. ON/OFF operation is recommended with strong signals and when position fixes are infrequently needed." Besten Gruß Vollkorn |
|||
26.12.2014, 10:50
Beitrag #2
|
|||
|
|||
RE: Command an Ublox senden
Hallo Vollkorn,
hier: http://dlnmh9ip6v2uc.cloudfront.net/data...PS/760.pdf gibt es eine komplette Kommando / Message - Übersicht, ua. auch für die CFG-Klasse. Ein Beispiel wie man Kommandos senden kann findet sich hier: http://playground.arduino.cc/UBlox/GPS Grüße Ricardo Nüchtern betrachtet...ist besoffen besser ![]() |
|||
26.12.2014, 20:11
Beitrag #3
|
|||
|
|||
RE: Command an Ublox senden
(26.12.2014 10:50)rkuehle schrieb: Hallo Vollkorn, Besten Dank ![]() |
|||
|
|
|
Benutzer, die gerade dieses Thema anschauen: 1 Gast/Gäste